Kentix MultiSensor-RACK Manuel de service télécharger pdf (Page 52)

Connection example 2: Leakage-sensor connected to MultiSensor

Plug the connection cable of the leakage-sensor into one of the jacks of the Kentix Power-Adapter (KIO1).

Connect the MultiSensor to the Power-Adapter with the modular cable (sent with the Power-Adapter).

Connect the delivered power supply to the Power-Adapter for currency.

The powering of leakage-sensor and MultiSensor is realized via the Power-Adapter, the alarming via the

external input of the MultiSensor.

With the ControlCenter enter a suitable name for the external alarm input and set the alarming of the input to

„Always-Active“ for a permanent alarming. If the leakage sensor is working with opening the contact on an

alarm, additionally change the alarm logic to „Open“.

MultiSensor-RF/LAN

Leakage-Sensor

KENTIX Power-Adapter

KENTIX System-jack

NOTE!

Using the leakage sensor together with a MultiSensor a fully wired patch cable is required for the

connection between MultiSensor and power adapter.

Page 52 ! ! ! ! (08-2014, subject to change) kentix.de

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 70 71

Pas de commentaire

Kentix MultiSensor-RACK Manuel de service Page 52