Kentix MultiSensor-RACK Manuel de service télécharger pdf (Page 50)

Operation KeyPad

First press the desired function key (arm, disarm, zone) and then enter your personal 4-digit code. The

function is triggered immediately after entering the fourth and last code digit. Each key-press is

acknowledged with an acoustic "beep". The selected function is indicated by an LED in the button.

By pressing one of the keys "arming" or "disarming" followed by entering your

personal code the zone assigned to the KeyPad is switched.

Note that every user needs the according permissions to use a KeyPad.

If you would like to arm-disarm the whole system (all zones), first press the zone

button and then button 1. Then run the desired function of the function key.

The LEDs are blinking according to the possible entries.

Basically for the KeyPad operation it is the same acoustic and optical feedback, such as for remote control

via mobile phone or an external switch contact.

Arming - leave the room

OK :

5 seconds acoustic beep signal, LED lights constant, MultiSensors signal acoustically

according to the time delay.

Not OK :

3 seconds constant acoustical signal. All LEDs are flashing.

Switch all zones

Controlled by pressing the zone button followed by button 1. After it the LEDs for the

possible functions for arm or disarm light up.

Disarming - enter the room

OK :

1 second constant acoustic signal, LED lights constant, MultiSensors signal also with 1

second acoustic signal.

RFID reader (Optional)

Select the desired function (arm, disarm, zone) and keep the RFID card centered on

the reader. The function is executed immediately after the correct read.

Important!

With the KeyPad only alarms of the type „Armed-Active“ can be switched to armed-disarmed.

Alarms of the type „Always-Active“ are triggered independent of the armed-disarmed state of the

AlarmManager. The sensors can be assigned individually to the two alarm levels.

Page 50 ! ! ! ! (08-2014, subject to change) kentix.de

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 70 71

Pas de commentaire

Kentix MultiSensor-RACK Manuel de service Page 50